1. Clean and dry the location where you want to paste with clean water.
2. Measure the approximate size of the sticker where you want to paste, then draw it on the back of the sticker, and cut out the approximate shape in advance.
3. Tear off the back paper of the cut sticker (do not tear it off all at once), stick one side, that is, fix one end of the sticker, and then use a scraper (similar to a credit card) to slowly scrape from top to bottom, and tear off the backing paper while scraping.
4. If there are creases or curvatures in the pasting position during the construction process, use a baking gun (you can use a household hair dryer instead) to heat and stretch the sticker so that it will not wrinkle (note that you can't blow it all the time, you have to feel whether it can be stretched while blowing, and don't stretch it too hard, stretch it slowly, and then stick it, scrape it, and tear off the backing paper, and tear off the backing paper wherever it is pasted).
5. After pasting, use a knife to cut off the excess part, and the edge part should be stuffed in 3-5 mm, or the edge should be baked with a hair dryer to ensure that the edge is flat and firm, so as to avoid shrinkage or warping of the sticker over time.
6. It is recommended that two people work at the same time to reduce the difficulty of construction. It is best to remove the car shell for easier construction.